Barge Flashing 90 degree, 200mm x 200mm - Polyester

Barges, sometimes known as Verges, are used at the end of a run of sheets to trim and seal off the edge of the roof.  All flashings are a vital part of any profiled clad roof, they not only help to weather proof the building but also add to it aesthetically too.

Click Here to order a sample of this product.

Barges are available in range of finishes and colours to match or contrast our roofing sheets depending on the look you are after. They are secured by stitching them (using st22 stitching screws) to the roofing sheet below. You will need to allow an overlap of a minimum 100mm when fitting barges end on end.

Manufactured as a 3m length and re folded to a 90 degree internal angle and will flex 10 – 15 degrees either way dependent on your needs. Cladco Barges come with a safety welt to increase strength of the material. 

Please note: 
The 200 x 200 flashings give a coverage of 192 x 192 due to the 8mm welt.
Length (meters): 3.0
£16.75Inc VAT